This HTML5 document contains 33 embedded RDF statements represented using HTML+Microdata notation.

The embedded RDF content will be recognized by any processor of HTML5 Microdata.

Subject Item

n2:

rdfs:label

Clone Recon trooper Clone Recon Trooper

rdfs:comment

The Clone commander Neyo, like all Phase II armor Clone Troopers not from The Clone Wars subtheme has a plain black head piece. The minifigure also has a leg piece made up of white legs with a black leg joint, with torso and helmet pieces with standard Phase II Clone Trooper printing on them. However, in addition to this standard printing is the red logo of the 91st Reconnaissance Corps, printed in the centre of the torso and on the top right-hand side of the helmet. A two red, horizontal stripes are also printed above the visor, with a gap between them in the middle. The minifigure features a red insignia on its helmet and chestblate.

dcterms:subject

n13: n16: n17: n18: n20: n21: n22: n24: n28: n29: n32:

n7:

n8: n9:

n3:wikiPageUsesTemplate

n4: n10: n25: n30: n35:

n26:

7250

n34:

Star WarsEpisode III: Revenge of the Sith

n11:

Clone Recon Trooper

n27:

2005

n31:

See Clone Trooper

n23:abstract

The minifigure features a red insignia on its helmet and chestblate. The Clone commander Neyo, like all Phase II armor Clone Troopers not from The Clone Wars subtheme has a plain black head piece. The minifigure also has a leg piece made up of white legs with a black leg joint, with torso and helmet pieces with standard Phase II Clone Trooper printing on them. However, in addition to this standard printing is the red logo of the 91st Reconnaissance Corps, printed in the centre of the torso and on the top right-hand side of the helmet. A two red, horizontal stripes are also printed above the visor, with a gap between them in the middle. The trooper's back printing is different in design. While some aspects along with the general outline of the armor remain the same, the standard backplate is replaced with a rectangle that is primarily white on the left and red on the right. White rectangles with grey outlining are printed towards the top left and bottom right of this large rectangle, along with a black horizontal line on the white side, and a small black rectangle and grey circle on the red. Underneath this main rectangle is a smaller rectangle, which is primarily red, with some white lines inside, and grey shapes around the edges. This trooper is armed with what was used as a gun before pieces specifically moulded to look like guns were released in 2007. This consisted of a black Part 4349, which is also commonly used as a megaphone, with a transparent light blue round stud on the end.

Subject Item

n5:

n15:

n2:

n6:

n2:

Subject Item

n19:

n6:

n2:

Subject Item

n33:

n6:

n2: